#Memorex external blu ray burner serial#

#Memorex external blu ray burner serial#

NOTE: The Serial ATA power connector is larger than the Serial ATA data cable connector. Connect the Serial ATA power connector to the power connector on the rear panel of your drive.If one is required, attach this 4-pin to Serial ATA power adapter to the 4-pin power connector from your PC power It depends on the power connectors of your PC power supply. (Optional) It may be necessary for you to use a 4-pin to Serial ATA power adapter.NOTE: The pin definition of Serial ATA data cable connector should be the same as that in the following figure. Connect the other end of the Serial ATA data cable to your drive.Connect a Serial ATA data cable to the Primary or Secondary Serial ATA port on the motherboard or PCI card of your PC.Find an empty bay, slide the drive into the bay and mount the drive by using 4 screws.Refer to your PC user's manual to remove the PC cover.Turn off your PC and disconnect all power cords.When disc spins up, before the drive settles into proper balanced spinning, there would be a winding noise if the disc is NOT perfectly balanced, which is normal.ДЄny scratching or impact noise are NOT normal. During this process, the balls have to be realigned to ensure balance. The noise came from balls moving into position.Дue many reasons, the spinning speed during reading has to be changed ( Commonly referred to as Spin-up / Spin-down ). While not spinning, these balls are free to roll about inside the ring, hence create some noises. The key to this operation is the ring of steel balls that can settle in place ensure total balance when the disc is spinning. Lite-On is using an ABS ( Auto-Balancing System ) to reduce vibration and noise during normal operation. Noises that sounded like loose parts inside when drive is handled while not mounted.

( Belt driven models will suffer from lost-tension of the belt after certain time ) Lite-On brand drives use gears to link motor and tray, therefore the normal operation is a little noisier than belt-driven models.